Back to Rivera Primo Home Page

Redesigned,
made stronger and more reliable.

blankInner Primary

#RE-C-30 for (1965 - 1969) Generator engines.
 Click here for more info on the REC-30

#RE-C-30B for (1970 - 1984) Alternator models. *4 lbs. heavier and reinforced!
 Click here for more info on the REC-30B

blankShift Lever Kits

#C-6 (With Forward Control)
New design ball bearing shift levers. Ends sloppy shifting on the late 1979 Thru 1986 4 speed.
The C-6 Shift Kit for forward control foot shifter as used on 1979-86 four speed transmissions.
The kit is a new cast lever in 356 Aluminum with heat treatment to T6, and then shot peened. The OEM inner had a steel bushing installed within a soft aluminum lever, which wore quickly even if it was greased regularly. We made a stronger lever and installed a double sealed ball bearing with a double metal shield. The original bolt is no longer used, we supply an Allen head socket shoulder bolt which is secured with thread locker into the bearing. The double-sealed, shielded, and permanently lubricated ball bearing is a superior replacement. We also install a new, hardened dowel pin.


#C-62 (With Thru-Primary Shifter)
The C-62 Shift Kit is an assembly like the C-6 for late 1979 thru 1986 4 speed (referred to as dome top, cowpie or rotary lid) transmissions. The C62 is used on thru primary shifters. Like the C-6, this is a new casting with double shielded and double sealed ball bearings. The two pins found on the OEM have been replaced with ground shoulder bolts which must have thread locker applied upon installation.

blankBack to Rivera Primo Home Page